68 P1512021 R64.18. Install the BeltThis section describes how to install the conveyor belt in the tube. Refer to the packing slip for the length of theconveyor belt used in the installation.Thread a Fish Tape through the Conveyor Tube1. Place the rolled belt on a stand behind the hopper.2. Pull the conveyor belt over the top of the hopper roller, until just inside the hopper, as shown below.Figure 38. Rolled Belt Behind a Typical Hopper3. Feed a fish tape in at the spout, through the tube, and into the hopper.4. Attach the end of the belt to the fish tape using a clamp, or use a short piece of belt and thread theconnector wire through the lacing clips to connect.Figure 39. Fish Tape Connected to a Short Piece of Belt4. ASSEMBLY PORTABLE GRAIN BELT CONVEYOR – STANDARD
