Remote Management CapabilitiesCyberSWITCH CSX400 and CSX400-DC Installation Guide2-3• The WPIM-T1/DDS provides both a T1 and DDS interface that allows you to easily switchbetween the two interfaces by changing the physical cabling and reconfiguring QuickSET forthe desired interface. The WPIM-T1/DDS has the capabilities of both the WPIM-T1 andWPIM-DDS.Ethernet LAN ConnectionThe CSX400 provides 10 Mbps Ethernet/IEEE 802.3 support through two Cabletron SystemsEthernet Port Interface Modules (EPIMs), which are available in a variety of media types.Appendix A, EPIM Specifications, details the available EPIMs that can be used to configure theCSX400 for an Ethernet connection.FLASH EEPROMs — The CSX400 uses a FLASH Electrically Erasable ProgrammableRead-Only Memory (EEPROM) that allows new and updated firmware to be downloaded inconjunction with Cabletron Systems QuickSET or any device using BootP or TFTP protocols.LANVIEW LEDs — Cabletron Systems LANVIEW Status Monitoring and Diagnostics System isa troubleshooting tool that helps in the diagnosing of power failures, collisions, cable faults, andlink problems. The LANVIEW LEDs are located on the CSX400 front panel.RESET Button — The front panel RESET button reboots the CSX400 and initializes theprocessor. The RESET button also is used with the mode switches to clear NVRAM.Remote Management CapabilitiesThe CSX400 can be remotely managed with any SNMP network management system includingthe following:• Cabletron Systems SPECTRUM for Open Systems Suite of Network Management Products• Cabletron Systems QuickSET• Third Party SNMP compliant Network Management Packages
