Cabletron Systems CyberSWITCH CSX400 Installation Manual

Also see for CyberSWITCH CSX400: Setup guide Configuration guide User guide User guide User guide

Contents

Chapter 4: Installation4-8CyberSWITCH CSX400 and CSX400-DC Installation GuideCSX-COMP/ENCR InstallationThis section contains instructions on how to install the CSX-COMP/ENCR into the CSX400motherboard. To help eliminate any potential problems during or after installation, read andunderstand all of the following steps:1. Attach one end of the antistatic wrist strap to your wrist and the other end to an approvedelectrical ground.2. Unpack the CSX-COMP/ENCR by carefully removing it from the shipping box and then fromthe protective plastic bag. Do not cut the bag as the device could be damaged. If there are anysigns of damage, contact the Cabletron Systems Global Call Center (refer to the Getting Helpsection).3. Power down the CSX400 before you install the CSX-COMP/ENCR.4. Remove the chassis cover of the CSX400 or CSX400-DC to install the CSX-COMP/ENCR(refer to Removing the CSX400 Cover on page 4-4 or Removing the CSX400-DC Cover onpage 4-5).5. Locate the D-Type connector and the standoffs on the CSX400 (refer to Figure 4-4).6. The D-Type connector pins of the CSX-COMP/ENCR only fit one way onto the CSX400D-Type connector. Lower the CSX-COMP/ENCR onto the standoffs and align the connectorwith the connector pins. Carefully insert the connector pins of the CSX-COMP/ENCR into theCSX400 connector.7. Press down firmly on the CSX-COMP/ENCR until the pins fit all the way into the connector.8. Secure the CSX-COMP/ENCR with the standoff screws supplied with the CSX-COMP/ENCR.The CSX-COMP/ENCR installation is complete.NOTEThe motherboard of the CSX400 has two D-Type connectors. Use the left-mostconnector (as you are facing the front of the chassis). Ensure the CSX-COMP/ENCRis aligned such that its connector pins correctly align with the D-Type connector on thechassis or module.