Chapter 5: Local Management5-486H122-08 User’s Guide5.15.6 Setting the Module TimeTo set the module clock, perform the following steps:1. Use the arrow keys to highlight the Module Time field.2. Enter the time in an 24-hour format, HH:MM:SS.3. Press ENTER to set the system clock to the time in the input field.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is a valid format, the Event Message Line at the top ofthe screen displays “SAVED OK”. If the entry is not valid, LocalManagement does not alter the current value and refreshes the ModuleTime field with the previous value.5.15.7 Entering a New Screen Refresh TimeThe screen refresh time is set from 3 to 99 seconds with a default of 3seconds. To set a new screen refresh time, perform the following steps:1. Use the arrow keys to highlight the Screen Refresh Time field.2. Enter a number from 3 to 99.3. Press ENTER to set the refresh time to the time entered in the inputfield.4. Use the arrow keys to highlight the SAVE command at the bottom ofthe screen and press ENTER.If the time entered is within the 3 to 99 seconds range, the Event MessageLine at the top of the screen displays “SAVED OK”. If the entry is notvalid, Local Management does not alter the current setting, but it doesrefresh the Screen Refresh Time field with the previous value.NOTEIf the 6C105 chassis has been assigned a chassis time, it is notnecessary to assign a module time to the 6H122-08. Allinstalled modules recognize the chassis time of the 6C105.NOTEWhen entering the time in the system time field, separatorsbetween hours, minutes, and seconds do not need to be addedas long as each entry uses two numeric characters. Forexample, to set the time to 6:45 A.M., type “064500” in theModule Time field.
