Chapter 1: SmartSwitch Router Product Overview1 - 4SSR User Reference ManualAccess ModesThe SSR CLI has four access modes.• User – Allows you to display basic information and use basic utilities such as pingbut does not allow you to display SNMP, filter and access control list information ormake other configuration changes. You are in User mode when the commandprompt ends with this character:>• Enable – Allows you to display SNMP, filter, and access control information as wellas all the information you can display in User mode. To enter Enable mode, enter theenable command, then supply the password when prompted. When you are inEnable mode, the command prompt ends with this character:#• Configure – Allows you to make configuration changes. To enter Configure mode,first enter Enable mode (enable command), then enter the configure commandfrom the Enable command prompt. When you are in Configure mode, the commandprompt ends with these characters:(config)#• Boot – This mode appears when the SSR the external flash card or the system imageis not found during bootup. You should enter the reboot command to reset the SSR.If the SSR still fails to bootup, please call Cabletron Technical Support.Ctrl-E Move cursor to end of lineCtrl-F Move cursor forward one characterCtrl-N Scroll to next command in commandhistory (use the cli show historycommand to display the history)Ctrl-P Scroll to previous command in com-mand historyCtrl-U Erase entire lineCtrl-X Erase from cursor to end of lineCtrl-Z Exit current access mode to previousaccess modeKey sequence Command
