Chapter 1: SmartSwitch Router Product Overview1 - 8SSR User Reference Manualbgp - Configure Border Gateway Protocol (BGP)cli - Modify the command line interface behaviordvmrp - Configure DVMRP related parametersexit - Exit current modefilters - Configure L2 security filtershttp - Configure SNMP related parameters.igmp - Configure IGMP related parametersinterface - Configure interface related parametersip - Configure IP related parametersip-router - Configure Unicast Routing Protocol relatedparametersipx - Configure IPX related parametersospf - Configure Open Shortest Path Protocol (OSPF)port - Configure Port parametersqos - Configure Quality of Service parametersrip - Configure Routing Information Protocol (RIP)snmp - Configure SNMP related parameters.stp - Configure STP parameterssystem - Configure system-wide parameterstacacs - Configure TACACS related parametersvlan - Configure VLAN-related parametersSpecial configuration mode commands:erase - Erase configuration informationnegate - Negate a command or a group of commandsusing line numbersno - Negate matching commandssave - Save configuration informationsearch - Look up a command in configurationshow - Show configuration commandsTo exit Configure mode and return to Enable mode, use one of the followingcommands:Boot PROM ModeIf your SSR does not find a valid system image on the external PCMCIA flash, thesystem might enter programmable read-only memory (PROM) mode. You should thenreboot the SSR at the boot PROM to restart the system. If the system fails to rebootsuccessfully, please call Cabletron Systems Technical Support to resolve the problem.To reboot the SSR from the ROM monitor mode, enter the following command.Exit Configure mode. exitCtrl-ZReboot in Boot PROM mode. reboot
