Cabletron Systems Spectrum 2E42-27 Management Manual

Also see for SmartSwitch 8H02-16: User guide

Contents

9032073 E2 Application Views5-13ATM Client ApplicationATM Client ApplicationThis section describes the ATM Client application supported by this device.This application is available when the appropriate High Speed InterfaceModule (HSIM) is installed.Table 5-6 lists the application-specific subviews available from the IconSubviews menu for the ATM Client application:ATM Client Application VCL ViewThis view provides a table containing detailed information about the virtualchannels passing through this application. The ATM Client ApplicationVirtual Channel Link view provides the following information.Admin StatusThis object is implemented only for a VCL that terminates a VCC (i.e., onethat is not cross-connected to other VCLs). Its value specifies the desiredadministrative state of the VCL. The Up state indicates that the traffic flowfor this VCL is enabled. The Down state indicates that the traffic flow for thisVCL is disabled.Oper StatusThis object shows the current operational status of the VCL. The Up andDown states indicate that the VCL is currently operational or not operational,respectively. The Unknown state indicates that the status of this VCL cannotbe determined.Last ChangeThis is the value of the MIB II’s sysUpTime object at the time the VCL enteredits current operational state. If the current state was entered prior to the lastre-initialization of the agent, then this object contains a zero value.RTD (Receive Traffic Description) IndexThe value of this object identifies the row in the ATM Traffic Descriptor Tablethat applies to the receive direction of this VCL.Table 5-6. ATM Client Application Subviews menuMenu Selection DescriptionConfiguration Opens the Device Configuration view described in Chapter3, Configuration Views.Model Information Opens the Model Information view described in theOperator’s Reference.VCL Table Opens the ATM Client Application VCL (Virtual ChannelLink) Table view described later in this chapter.Interfaces Opens the Interfaces view described later in this chapter.