Black plate (7,1)Cadillac DTS Owner Manual - 2011Laws in some communities may restrict the use ofremote starters. For example, some laws may require aperson using remote start to have the vehicle in viewwhen doing so. Check local regulations for anyrequirements on remote starting of vehicles.Do not use the remote start feature if your vehicle is lowon fuel. Your vehicle may run out of fuel.If your vehicle has the remote start feature, the RKEtransmitter functions will have an increased range ofoperation. However, the range may be less while thevehicle is running.There are other conditions which can affect theperformance of the transmitter, see Remote KeylessEntry (RKE) System Operation on page 3‑4 foradditional information./ (Remote Start): This button will be on the RKEtransmitter if you have remote start.To start the vehicle using the remote start feature:1. Aim the transmitter at the vehicle.2. Press and release the transmitter's lock button,then immediately press and hold the transmitter'sremote start button until the turn signal lights flashor if the vehicle's lights are not visible, press andhold the remote start button for at leastfour seconds. Pressing the remote start buttonagain after the vehicle has started will turn off theignition.When the vehicle starts, the parking lamps will turnon and remain on while the vehicle is running. Thevehicle's doors will be locked.3. If it is the first remote start since the vehicle hasbeen driven, repeat these steps, while the engineis still running, to extend the engine running timeby 10 minutes. Remote start can be extendedone time.After entering the vehicle during a remote start, insertand turn the key to ON/RUN to drive the vehicle.If the vehicle is left running it will automatically shut offafter 10 minutes unless a time extension hasbeen done.To manually shut off a remote start:. Aim the RKE transmitter at the vehicle and pressthe remote start button until the parking lampsturn off.. Turn on the hazard warning flashers.. Turn the ignition switch on and then off.The remote vehicle start feature provides two separatestarts, each with 10 minutes of engine running, or itprovides one start with 10 minutes of engine runningthat may be extended 10 more minutes. If you pressand release the transmitter lock button and then pressand hold the remote start button on the RKE transmitteragain before the first 10 minutes of engine running timehas expired, 10 minutes are added to the remaining3-7