How to Add FluidRefer to the Maintenance Schedule to determine whatkind of transmission fluid to use. See RecommendedFluids and Lubricants on page 6-13.Add fluid only after checking the transmission fluid whileit is hot. A cold check is used only as a reference.If the fluid level is low, add only enough of the properfluid to bring the level up to the HOT area for a hotcheck. It does not take much fluid, generally less thanone pint (0.5 L). Do not overfill.Notice: Use of automatic transmission fluid labeledother than DEXRON®-III, Approved for theH-Specification, may damage your vehicle, and thedamages may not be covered by your warranty.Always use automatic transmission fluid labeledDEXRON ®-III, Approved for the H-Specification.• After adding fluid, recheck the fluid level asdescribed under “How to Check,” earlier inthis section.• When the correct fluid level is obtained, push thedipstick back in all the way; then flip the handledown to lock the dipstick in place.Engine CoolantThe cooling system in your vehicle is filled withDEX-COOL® engine coolant. This coolant is designedto remain in your vehicle for five years or 150,000 miles(240 000 km), whichever occurs first, if you add onlyDEX-COOL® extended life coolant.The following explains your cooling system and how toadd coolant when it is low. If you have a problem withengine overheating, see Engine Overheating onpage 5-26.A 50/50 mixture of clean, drinkable water andDEX-COOL® coolant will:• Give freezing protection down to −34°F (−37°C).• Give boiling protection up to 265°F (129°C).• Protect against rust and corrosion.• Help keep the proper engine temperature.• Let the warning lights and gages work as theyshould.Notice: Using coolant other than DEX-COOL® maycause premature engine, heater core or radiatorcorrosion. In addition, the engine coolant mayrequire changing sooner, at 30,000 miles (50 000 km)or 24 months, whichever occurs first. Any repairswould not be covered by your warranty. Always useDEX-COOL ® (silicate-free) coolant in your vehicle.5-23
