When cleaning the cassette tape player with therecommended non-abrasive cleaning cassette, it ispossible that the cassette may eject, because the cuttape detection feature on your radio may recognize it asa broken tape, in error. To prevent the cleaningcassette from being ejected, use the following steps:1. Turn the ignition on.2. Turn the radio off.3. Press and hold the TAPE DISC button for fiveseconds. READY will appear on the display andthe cassette symbol will flash for five seconds.4. Insert the scrubbing action cleaning cassette.5. Eject the cleaning cassette after the manufacturer’srecommended cleaning time.When the cleaning cassette has been ejected, the cuttape detection feature is active again.You may also choose a non-scrubbing action, wet-typecleaner which uses a cassette with a fabric belt toclean the tape head. This type of cleaning cassette willnot eject on its own. A non-scrubbing action cleanermay not clean as thoroughly as the scrubbing typecleaner. The use of a non-scrubbing action, dry-typecleaning cassette is not recommended.After you clean the player, press and hold the ejectbutton for five seconds to reset the CLEAN indicator.The radio will display --- or CLEANED to show theindicator was reset.Cassettes are subject to wear and the sound qualitymay degrade over time. Always make sure the cassettetape is in good condition before you have your tapeplayer serviced.Care of Your CDs and DVDsHandle discs carefully. Store them in their original casesor other protective cases and away from direct sunlightand dust. If the surface of a disc is soiled, dampena clean, soft cloth in a mild, neutral detergent solutionand clean it, wiping from the center to the edge.Be sure never to touch the side without writing whenhandling discs. Pick up discs by grasping the outeredges or the edge of the hole and the outer edge.Care of Your CD ChangerThe use of CD lens cleaner discs is not advised, due tothe risk of contaminating the lens of the CD opticswith lubricants internal to the CD mechanism.3-101
