User Manual – Rev AY AMETEK Programmable PowerMX Series 1444.7.4 Pulse TransientsPulse transients let you program the output to a specified value for a predetermined amount oftime. At the end of the Pulse transient, the output voltage returns to its previous value.Parameters required to set up a Pulse transient include the pulse count, pulse period, and pulseduty cycle. An example of a Pulse transient is shown in Figure 4-42. In this case, the count is 4,the pulse period is 16.6 ms or 60 Hz and the duty cycle is 33%.Figure 4-42: Pulse TransientsNote that Pulse transients can only be programmed over the bus, not the front panel. Refer to theSCPI Programming Manual for more information about programming Pulse transients andtriggers.
