User Manual – Rev AY AMETEK Programmable PowerMX Series 91CURR 0CURR FS HTCURR 0 HTPREVIOUS SCREENSeries II only Series I onlyOUTPUT CAL VOLT FS VOLT FSVOLT ZERO V HI-FREQPHASE OFST VOLT ZEROIHARM FS PHASE OFSTIMP. REAL FS IMP. REAL FSIMP. REACT FS IMP. REACT FSIMP. REAL MIN IMP. REAL MINIMP. REACT MIN IMP. REACT MINPREVIOUS SCREEN PREVIOUS SCREEN4.2.4 PROGRAM MenuFigure 4-8: PROGRAM MenuThe PROGRAM menu is shown in Figure 4-8. It can be reached in one of two ways:1. by selecting the PROGRAM entry in the MENU screen and pressing the ENTER key2. by pressing the PROG key in the FUNCTION keypadThe PROGRAM menu is used to change output parameters. The most commonly usedparameters are all located in PROGRAM 1. The PREVIOUS SCREEN entry, when selected, willreturn the user to the most recently selected menu. This is normally the MENU screen unless thePROGRAM menu was selected using the PROG key on the FUNCTION keypad. Less frequentlyused parameters are located in PROGRAM 2, which can be reached from the PROGRAM 1screen using the MORE selection, or by pressing the PROGRAM key twice.The following choices are available in the PROGRAM menus:Entry DescriptionPROGRAM 1VOLTAGE Programs the output voltage in Vrms while in AC mode orabsolute voltage when in DC mode. In DC mode, negativevalues can be entered.FREQ Programs the output frequency when in AC mode. If the unit isin DC mode, the value for FREQ will be set to DC and cannot bechanged until AC mode is selected. When in AC mode, thefrequency can be changed from 16 Hz to 500 Hz. Valuesentered that fall outside this range will generate a -200 RANGEERROR and will not be accepted.VOLT RANGE Selects 150V, 300V or optional 400V range in AC mode and200V or 400V range in DC mode. The actual range values maybe different depending on the configuration. The value of thisfield can only be changed with the shuttle or the +/- key.
