CamRanger CamRanger User Manual

Also see for CamRanger: User manual User manual User manual User manual

CamRanger CamRanger User Manual Manual pdf 6 page image

Enter the 8-character CamRanger serial number. The serial number is located both on theboOom of the back cover as well as above the baOery underneath the back cover. Note: theserial number contains only leOers and NO numbers.Press the “Register” buOon to register. A message box will appear indicaLng registraLon wassuccessful and the iOS device can be used with the CamRanger. Exit the app and then proceedwith the setup process as detailed below in the CamRanger Setup secLon.If registraLon fails, confirm Internet connecLvity and the CamRanger serial number beforecontacLng contact@CamRanger.com for assistance.CamRanger SetupPower on the CamRanger and confirm that all four lights briefly appear. The CamRanger willtake approximately 30 seconds unLl it is fully iniLalized.The first Lme the user connects to CamRanger from an iOS device (iPad, iPhone, or iPod Touch),the iOS device needs to be registered. See the CamRanger RegistraLon secLon above.On the iOS device connect to your CamRanger network. The SSID will be CamRanger-###, withthe last three characters matching the last 3 characters of the CamRanger’s serial number. Thepassword is the full 8 characters of the CamRanger’s serial number. The password MUST BEENTERED IN ALL CAPS. The keyboard on newer iOS versions can be put into caps lock by doubletapping the shif key.Connect the CamRanger to the camera with the provided black USB cable. The male A end isinserted into the USB port at the end of the CamRanger, and the other end is connected to theUSB port of the camera. Then ensure the camera is turned on. When the camera is connectedand turned on the green light closest to the edge of the CamRanger device will light.Launch the CamRanger iOS app. The applicaLon will connect to the CamRanger and the userwill be able to control the camera.For common problems with setup and connecLon refer to the TroubleshooLng secLon at theend of the manual.Firmware UpdateIt is recommended to check the iOS app and firmware version before using the CamRanger toensure they are the latest version. The app must be at least 2.0 and the firmware version 6 tosupport network bridging, sharing features, or the CamRanger PT Hub and MP-360 (or MP 101,Bescor, or Hague). To update the CamRanger firmware, visit camranger.com/downloads forfurther instrucLons on update.To check the CamRanger app and firmware version, refer to the ‘Help’ tab within theCamRanger sejngs. The iniLal digits listed afer CamRanger indicate the app version and the© CamRanger – Patent Pending 6