Cannon C60DP Use And Installation Instructions

Also see for Professional 60: Use and Installation Instructions User instructions

Contents

Carefully slide the inner glass towards you and withdraw itfrom its locating slots.Ensure that the door is not allowed to slam shut, due to thereduction in door weight.Clean the glass as described above.Refit the door inner glass as follows.1. Open the door fully.2. Locate the inner door glass into its slots, so that the printing is readable from theface nearest the oven in the closed position and the widest black band is towardsthe bottom of the door. The inner door glass has a special reflective coating on oneside, in order to minimise surface temperatures and energy consumption duringuse, it is important it is fitted correctly.3. Carefully slide the glass into its slots as far as it will go and replace the end caps.2.3. The inside of the outer door glass can now be cleaned while still fitted to the cooker.NEVER OPERATE THE COOKER WITHOUT THE INNER DOOR GLASS IN POSITION.CLEANING THE DOORSTake particular care not to damage the inner surface of the door inner glass thatis coated with a heat reflective layer. Do not use scouring pads, or abrasivepowder, which will scratch the glass.Ensure that the glass panel is not subjected to any sharp mechanical blows.Stubborn stains can be removed by using a fine steel wool soap pad. For slight soilingthe inner glass panel may be cleaned, while still warm, without removing it from thedoor. After cleaning, rinse and dry with a soft cloth.SIDE OPENING DOORCleaning the door glass is the same as the drop down door, except take care tosupport the weight of the inner glass when removing and refitting.DROP DOWN DOORSRemove the door inner glass as follows.1. Open the door fully and remove the extrusion end caps (This should be done byhand but if it proves too difficult, simply lift the inner glass to ease the end caps outof position).Note: If you need to use a tool - be careful not to damage the extrusion or endcap.30CARE AND CLEANING