Cannon Professional 60 C60GP Use And Installation Instructions

Contents

UNPACKING THE COOKERUnpack the components from inside the grill and oven: Check that the following partsare present.Grill pan and grid Top oven shelf heat shieldBaking dish Pan supportsMain oven shelves (2) Enamelled burner caps (4)Top oven shelf (1) LiteratureAluminium burner bodies(4)LEVELLINGFour skid feet are fitted which can be adjusted up or down to level the cooker.CONVERSION FOR USE ON BUTANE (G30) OR PROPANE (G31)Each burner requires the injector to be replaced and bypass screws adjusted or replaced asfollows:1. Remove the loose hotplate burner parts.2. Using a 7mm socket, replace the hotplate injectors as appropriate (see table onprevious page).3. Re-position the loose burner parts.4. Remove the enamelled baffle at the front of the grill (2 screws).5. Remove the screw on the right hand side of the burner and gently slide the burneroff the injector.6. Using a 7mm socket, replace the grill injector as appropriate (see table on previouspage).7. Re-assemble the burner and baffle.8. Inside the top oven, remove the central screw securing the burner retainer. Slide theretainer to the right slightly and lift away.9. Lift the burner assembly and place on the floor of the oven to the right of the burneropening.10. Using a 7mm socket, replace the oven injector as appropriate (see table on previouspage).11. Re-assemble the oven burner and retainer.12. Replace the main oven injector following the same procedure as for the top oven.13. From behind the cooker, remove the screws securing the rear panel and swing theleft hand side outwards (viewed from the rear) to gain access to the main oven flamesupervision device.14. Replace the flame supervision device bypass screw.15. Re-assemble the rear panel.16. Carefully pull off the control knobs and timer buttons.17. Remove the 2 screws securing the underside of the control panel. Slide the controlpanel to the left slightly to remove.continued...31INSTALLATION INSTRUCTIONS