Cannon Professional 60 C60GP Use And Installation Instructions

Contents

Connection to the electricity supply should be made via a properly earthed, readily accessiblewall socket which is adjacent to but not directly above, and not more than 1.25m away from theappliance and capable of electrical isolation.The mains lead should be routed such that it cannot touch hot parts of the cooker i.e. the backpanel above a height of 650mm from the floor.Should this plug not fit the socket outlet in your home it should be cut off and replaced with asuitable plug as outlined below.NOTE: The removed plug cannot be used for any other appliance and should therefore beproperly disposed of and not left where children might find it and plug it into a supply socket –with the obvious consequent danger.IF THE FITTED PLUG IS REMOVEDThe flexible mains lead must be correctly connected as below to a three pin plug of not lessthan 13 amp capacity. If a B.S. 1363 fused plug is used, it must be fitted with a fuse which isapproved to B.S. 1362.IMPORTANT: The wires in the mains lead fitted to thisappliance are coloured inaccordance with the following code:GREEN AND YELLOW – EARTHBLUE – NEUTRALBROWN – LIVEAs the colours of the wires in the mains lead of this appliance may not correspond with thecoloured markings identifying the terminals in your plug, proceed as follows:– The wire which iscoloured green and yellow must be connected to the terminal in the plug which is marked withthe letter E or by the earth symbol or coloured green or green and yellow. The wire which iscoloured blue must be connected to the terminal which is marked with the N or coloured black.The wire which is coloured brown must be connected to the terminal which is marked with theletter L or coloured red. When wiring the plug, ensure that all strands of wire are securelyretained in each terminal. Do not forget to tighten the mains lead clamp on the plug. As theappliance must be earthed, do not use 2-pin sockets outlets, if you are in doubt, consult aqualified electrician.Should the mains lead ever require replacement, it is essential that this operation be carried outby a qualified electrician and should only be replaced with a flexible cord of the same size i.e.1.0mm 2 cross sectional area PVC cable, available from our parts department (see Back Cover).IF A MOULDED PLUG IS FITTEDIn the event of replacing a fuse in the plug supplied an ASTA approved fuse to BS1362 must befitted.NOTE: The fuse cover must be refitted when changing the fuse. In the event of losing the fusecover the plug must not be used until a replacement fuse cover has been obtained and fitted. Anew fuse cover can be obtained from your local Electricity Board. The colour of the correctreplacement fuse cover is that of the coloured marks or inserts in the base of the plug.Make sure that the cable does not become trapped when pushing the cooker into position.33ELECTRICAL CONNECTIONWARNING – THIS APPLIANCE MUST BE EARTHED.CONNECT TO A 230-240V A.C. SUPPLY ONLY.Green &Yellow toEarthBrown toLiveBlue toNeutralCord Clamp 3 AmpFuse

/ 36

Related manuals for Cannon Professional 60 C60GP