39Masteringthe BasicsPlaying Back with the Built-in Speaker/Headphones❍ When using the built-in speaker, make sure that “H” is not displayed on thescreen. When using the headphones, make sure that “H” is displayed. Changethe setting as necessary ( 70).❍ The built-in speaker does not sound when “H” is displayed.❍ Do not connect headphones unless “H” is displayed as it produces noise.❍ The built-in speaker is monaural. Use headphones for stereo sound.❍ The setting has to be done separately for each operating mode. Make sure tochange the setting when you have change the operating mode.Adjusting the VolumeTurn the selector dial up to increase the volume, anddown to lower the volume.• A volume bar appears for 4 seconds.• You can turn off the volume completely by turning the selectordial down until [OFF] appears. Turn the selector dial up to increase the volume again.❍ Sound may become distorted when the volume is turned up too high.❍ The headphone volume can be adjusted in all operating modes.❍ The camcorder retains the setting even if you turn it off (separately forheadphones and built-in speaker).❍ See also Using Headphones during Recording ( 70).CARD PLAY (VCR)CARD CAMERAPLAY (VCR)CAMERAESelector dial Built-in speaker H (phones) terminal