Chapter 44-13No response #751 - Server has not bootedup.- Network disconnected.(If connection cannot bemade with transmissiondestination, connectionis sometimes cut mid-way.)- Reset caused byinternal error.Processing interrupted.- Check transmission destination and network settings.- Transmission jobs whose processing has stopped forsome reason or other are forced to quit by assigning aninternal error code (#751). As a result, after rebooting,the job is not run.TCP/IP error #755 - IP address set to0.0.0.0. In the followingtwo situations, the IPaddress is 0.0.0.0.1) Address could not beobtained from DHCP,BOOTP, RARP.2) Unit launched in IPfixed mode(keys 1+7 toenter FIXIPmode).- TCP/IP protocol stackresources insufficient.Even with internal retry(5 times),transmissionfailed.- Set the IP address correctly or set DHCP, RARP,BOOTP environments to operate properly.- Turn power OFF/ON.Check server #801 - Error generated due tocause on server side.- SMB server side filecapacity not sufficient.- In WindowsNT/2000server, password wasincorrect.- In WindowsNT SMB,common file name didnot match.- In SMB, a user existsbut no write privileges.- SMB transmissionmade to write-prohibited file of thesame name.- Reset server.- Check server status and settings.- Check the network traffic.Cannot find server #802 DNS/SMTP settingerror(DNS error)Reprogramme the user mode settings. (domain name, E-Mail address, DNS, mail server)Check address #804 - No match for specifieddirectory name.- In SMB, a user existsbut no write privileges.- Check that the destination directory name is correct.- Set directory access privileges in the server.Check address. #806 - Wrongly specified username.- Wrongly specifiedpassword. (Excl.Windows NT.)- Change address book user name or password.No messag #807 No access rights for thespecified directory- Check the access rights to the server.Message Error code Cause Remedy