Canon HV30E Instruction Manual

Contents

Canon HV30E Instruction Manual Manual pdf 87 page image

Trouble? 87Additional InformationList of MessagesSome error messages will disappear after being displayed for about 4 seconds.Message Explanation/SolutionSET THE TIME ZONE,DATE AND TIMEYou have not set the time zone, date and time. This messageappears each time you turn the power on until you set the timezone, date and time.22CHANGE THE BATTERYPACKBattery pack is exhausted. Replace or charge the battery pack. 16THE TAPE IS SET FORERASURE PREVENTIONCassette is protected. Replace the cassette or change the positionof the protect switch.91REMOVE THE CASSETTE Camcorder stopped operating to protect the tape. Remove thecassette and reinsert it.18CHECK THE HDV/DVINPUT(Appears only if a DV cable isconnected)The DV cable is not correctly connected to the HDV/DV terminal, orthe connected digital device is turned off.65The video input signal is in a different television system (NTSC). –CONDENSATION HASBEEN DETECTEDCondensation has been detected in the camcorder. 93CONDENSATION HASBEEN DETECTEDREMOVE THE CASSETTECondensation has been detected in the camcorder. Remove thecassette.93TAPE END Tape reached the end. Rewind the tape or replace the cassette. –INCORRECT TAPESPECIFICATIONYou attempted to play back a tape recorded in a different televisionsystem (NTSC) or in a recording standard not supported by thiscamcorder.–INPUT SIGNAL NOTSUPPORTEDThe digital device connected with the DV cable is incompatible withthe camcorder.–PLAYBACK STD LOCKEDINCOMPATIBLE VIDEOINPUTCurrent camcorder settings do not match the HDV/DV standard ofthe video input signal. Change the [PLAYBACK STD] setting tomatch the video input signal.38PLAYBACK STD LOCKEDPLAYBACK ISRESTRICTEDCurrent camcorder settings do not match the HDV/DV standard ofthe recording you tried to play back. Change the [PLAYBACK STD]to match the recording standard of the tape.38HEADS DIRTY, USECLEANING CASSETTEVideo heads are dirty. Clean the video heads. 93NO CARD There is no memory card in the camcorder. 18NO IMAGES No images are recorded on the memory card. –CARD ERROR A memory card error occurred. The camcorder cannot record ordisplay the image.The error may be temporary. If the message disappears after 4seconds and “ ” flashes red, turn the camcorder off, remove thecard and reinsert the card. If “ ” changes to green or yellow, youcan continue recording/playback.–CARD FULL Memory card is full. Erase some images to free some space orreplace the memory card.63COPY