Specifying Common Settings5-30Customizing Settings55 Press [ ] or [ ] to select or ➞ press [OK].If you want to use an output tray for only one function, select only for thatfunction.Repeat steps 4 and 5 to set Tray Designation settings for the other functions.The Tray Designation setting is set.IMPORTANTIf a certain tray reaches its stacking limit, the machine automatically uses anothertray that is designated for the same function. However, it is recommended that youonly designate one tray for fax documents to prevent them from getting lost.6 Press [Stop] to return to the Standby display.Standard Paper for the Stack BypassYou can set the paper size and type that the stack bypass uses beforehand. Thissetting is useful if you always load the same paper size and type into the stackbypass.IMPORTANT• When printing on special types of paper, such as heavyweight paper or transparencies,be sure to correctly set the paper type, especially if you are using heavyweight paper. Ifthe type of paper is not set correctly, it could adversely affect the quality of the image.Moreover, the fixing unit may become dirty and require a service repair, or the papercould jam.• If you set the standard paper size and type for the stack bypass, the paper size/type isfixed, and you cannot select a different paper size/type for the stack bypass.NOTE• If you are using the stack bypass as a paper source for the Copy and Fax functions, youmust select the stack bypass when specifying the Drawer Eligibility for APS/ADS setting.(See "Auto Paper Selection/Auto Drawer Switching," on p. 5-23.)• The default setting is 'OFF'.OKCOPY ON TRAY A2.PRINTERStop
