Canon ImagePROGRAF iPF680 User Manual

Also see for ImagePROGRAF iPF680: User guide User guide Service guide User guide

Cause Corrective ActionPaper has been loadedaskew, or warped paperhas been loaded.3. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press theOK button.Printing will resume, starting from the page on which the error occurred.If this error recurs after you reload the roll, remove the Roll Holder from the printer, push the roll firmly in untilit touches the Roll Holder flange, and reload the Roll Holder in the printer.(See "Attaching the Roll Holder to Rolls.") ➔ P.370Follow these step to reload a sheet.1. Push the Release Lever back.2. Load the sheet, aligning it with the guide on the right.(See "Loading Sheets in the Printer.") ➔ P.3923. Pull the Release Lever forward.4. If "Not finished printing. Finish printing remaining jobs?" is shown on the Display Screen, press theOK button.Printing will resume, starting from the page on which the error occurred.Insufficient paper for jobInsufficient paper for jobCause Corrective ActionThe printer has received a print job longer than the amount of roll paper left whenManageRemainRoll in the Control Panel menu is On.Press ▲ or ▼ to select Print, and then press theOK button to resume printing.However, the roll paper may run out during theprint job and you may not be able to print all of thedocument.Press ▲ or ▼ to select Change Paper, and thenpress the OK button to stop printing.Either change the printer driver Paper Sourcesetting or the GL2 Settings > Paper Source set-ting in the printer menu or replace the roll with aroll that has enough paper for the print job, andthen try printing again.(See "Removing the Roll from the Print-er.") ➔ P.378(See "Loading Rolls in the Printer.") ➔ P.373Press ▲ or ▼ and select Stop Printing or pressthe Stop button to stop printing.This paper cannot be used.This paper cannot be used.Cause Corrective ActionPaper smaller than the printer's minimum supportedsize has been loaded.Push the Release Lever back and load paper of the correct size.(See "Paper Sizes.") ➔ P.360Paper has been loaded that is too small to print the testpattern for printhead adjustment or nozzle checking.Push the Release Lever back and load unused paper of A4 size or larger.More than one sheet may be required depending on the adjustment.Roll printing is selected.Roll printing is selected.Cause Corrective ActionYou have attempted to print on a roll, butno roll is loaded.Press ▲ or ▼ to select "Load Roll Paper", and then press the OK button. Load the roll, andthen print.(See "Attaching the Roll Holder to Rolls.") ➔ P.370(See "Loading Rolls in the Printer.") ➔ P.373Press ▲ or ▼ and select Stop Printing or press the Stop button to stop printing.iPF680 Insufficient paper for jobUser's GuideError Message Messages regarding paper613