Canon LEGRIA HFM406 Instruction Manual

Contents

160 Additional InformationThe camcorder is connected using the supplied HDMI cable, but there is no picture or soundfrom the HDTV.- Disconnect the supplied HDMI cable and then restore the connection or turn the camcorder offand then on again.The camcorder is connected using the supplied HDMI cable, but HDMI-CEC does not work(cannot play back using the TV’s remote control).- Disconnect the HDMI cable and turn off the camcorder and the TV. After a short while turnthem on again and restore the connection.- 68 [Control for HDMI] is set to [Off]. Set it to [On].- HDMI-CEC is not activated on the connected TV. Activate this function on the TV.- Even with TV sets compatible with HDMI-CEC the range of functions available differs depend-ing on the type of TV. Refer to the instruction manual of the connected TV.The computer does not recognize the camcorder even though the camcorder is connectedcorrectly.- Disconnect the USB cable and turn off the camcorder. After a short while, turn it on again andrestore the connection.- Connect the camcorder to a different USB port on the computer.Cannot save photos on my computer- When the memory contains too many photos (Windows – 2,500 photos or more, Macintosh –1,000 photos or more), you may not be able to transfer photos to a computer. Try using a cardreader to transfer the photos on the memory card. only: To transfer the photos in thebuilt-in memory, copy them to the memory card in advance (0 120).List of Messages (in alphabetical order)Accessing the memory card. Do not remove the memory card.- You opened the double memory card slot cover while the camcorder was accessing the mem-ory card or the camcorder started accessing the memory card as you opened the doublememory card slot cover. Do not remove the memory card until this message disappears.Back up recordings regularly- This message may appear when you turn on the camcorder. In the event of a malfunction,recordings may be lost so back up your recordings regularly.Buffer overflow. Recording was stopped.- The data transfer rate was too high for the memory card in use and the recording wasstopped. Replace the memory card with one rated SD Speed Class 2, 4, 6 or 10.- After repeatedly recording, deleting and editing scenes (fragmented memory), it will takelonger to write data on the memory and recording may stop. Save your recordings (0 123)and initialize the memory (0 38).Built-in memory error- The built-in memory could not be read. Contact a Canon Service Center.