Canon MP 700 Service Manual

Contents

4-19MultiPASS MP730/MP700 Chapter 4: Maintenance and Servicec) ERROR CODE LISTThe error codes that have newly been added starting with the product are identified by thenotation “new” those error codes for which remedies unique to the product are offered areidentified by the notation “UNQ (UNIQUE).”c-1) User error codeNo. Tx or Rx Definition#001 [TX] Document has jammed#003 [TX/RX] Document is too long, or page time-over#005 [TX/RX] Initial identification (T0/T1) time-over#006 [TX] Transmission cannot be made[RX] Phase synchronization fails in OLD-FM#008 [TX] Password does not match for polling transmission#009 [RX] Recording paper has jammed or the recording paper has run out#011 [RX] Polling reception error#012 [TX] The other party has run out of recording paper#018 [TX/RX] Auto dialing transmission error#021 [RX] The other party has rejected the machine during polling reception#022 [TX] Call fails#037 [RX] Memory has overflowed when receiving images#052 [RX] Image memory full by no ink errorUNQ #085 [TX] Other party does not support ITU-T Color Faxing#995 [TX/RX] Memory Communication reservation cancellationc-2) Service error codeNo. Tx or Rx Definition##100 [TX] The number allowed for retransmission of the procedure signalwas exceeded during transmission##101 [TX/RX] The modem speed of the machine does not match that of theother party##102 [TX] Fallback is not possible##103 [RX] EOL cannot be detected for 5 sec (15 sec if CBT)##104 [TX] RTN or PIN has been received##106 [RX] The procedure singal cannot be received for 6 sec while in wait##107 [RX] The transmitting machine cannot be use fallback##109 [TX] After transmitting DCS, a signal other than DIS, DTC, FTT,CFR, and CRP was received, exceeding the permitted number oftransmissions of the procedure signal##111 [TX/RX] Memory error##114 [RX] RTN was transmitted##200 [RX] During image reception, a carrier is not detected for 5 sec##201 [TX/RX] DCN was received through a non-normal procedure##204 [TX] Receive DTC without Tx data##220 [TX/RX] System error (e.g., main program may have gone away)##224 [TX/RX] Fault occurred in the communication procedure signal