Canon MX450 series Online Manual

Also see for MX450 series: Setup manual Setup guide Online manual Online manual Online manual

Contents

Problems Sending FaxesCannot Send a FaxCannot Perform Sequential Broadcasting by Redialing, or Cannot Dial Using the Numeric ButtonsErrors Often Occur When You Send a FaxCannot Send a Fax• Check 1: Is the power turned on?• You cannot send faxes if the power is turned off. Press the ON button to turn the power on.• If you unplugged the power cord without turning off the power (the POWER lamp is lit),reconnecting it turns on the power automatically.• If you unplugged the power cord after pressing the ON button to turn off the power (the POWERlamp is off), reconnect it, then press the ON button to turn on the power.• If the power was turned off due to power failure, etc., the power is automatically turned on whenthe power failure is resolved.ImportantConfirm that the POWER lamp is off before unplugging the power cord, then unplug the powercord.If a power failure occurs or you unplug the power cord, all faxes stored in the machine's memoryare deleted.For details on how to unplug the power cord, refer to Notice for Unplugging the Power Cord.NoteIf the faxes stored in the machine's memory are deleted by a power failure or unplugging thepower cord, the list of the faxes deleted from the machine's memory (MEMORY CLEAR REPORT)will be printed after turning the machine on.For details, see Summary of Reports and Lists.• Check 2: Is the document being sent from memory or the fax being received intomemory?When the message for the transmission/reception is displayed on the LCD, a fax is being sent from/received into machine's memory. Wait until the transmission/reception is complete.• Check 3: Is the machine's memory full?Delete contents in memory, then send a fax again.Deleting a Document in Machine's Memory• Check 4: Is the telephone line type set correctly?Check the telephone line type setting and change it as necessary.Setting the Telephone Line Type• Check 5: Is On-hook setting set to Disable?When you send a fax manually, dial the number with Enable selected for On-hook setting in Securitycontrol under Fax settings, or dial the number using the telephone connected to the machine.Security control• Check 6: Is Dial tone detect set to ON?Resend the fax after a while.If you still cannot send the fax, select OFF for Dial tone detect in Adv. FAX settings under Faxsettings.Adv. FAX settings• Check 7: Is the fax number registered correctly for memory dialing?Check the recipient's fax/telephone number, correct the fax/telephone number registered to thememory dial code, then send the document again.