Check6 Make sure that the network settings of the computer are correct.For the procedures to connect a network device to the computer and set them up, refer to the instructionmanual of your network device or contact its manufacturer.Check7 Make sure that the radio status is good and adjust the installation positionswhile monitoring the radio status with IJ Network Tool.Monitoring Wireless Network StatusCheck8 Make sure that a valid wireless channel is used.The wireless channel to be used may be limited depending on wireless network devices installed in thecomputer. Refer to the instruction manual provided with your computer or your wireless network device tospecify the valid wireless channel.Check9 Make sure that the channel confirmed in Check 8 can communicate with thecomputer.If not, change the channel set to the wireless router.Check10 Make sure that the firewall of the security software is disabled.If the firewall function of your security software is turned on, a message may appear warning that Canonsoftware is attempting to access the network. If the warning message appears, set the security software toalways allow access.If using any programs that switch the network environment, check their settings. Some programs will enable afirewall by default.Check11 When using a router, connect the machine and computer to the LAN side(same network segment).If the problem is not resolved, perform setup again with the Setup CD-ROM or perform it according to theinstructions on our website.• For placement:Make sure that there is no barrier or obstacle between the wireless router and the machine.Note• When you connect the machine to a Windows XP computer by cableless setup:Follow the procedure below to perform settings of the machine and the computer.1. Enable the access point mode of the machine.2. Right-click the Wireless Network Connections icon on the notification area on the desktop,then click View Available Wireless Networks.3. Select the network name on the screen displayed, then click Connect.Select "XXXXXX-MXXXXseries" ("XX" represents alphanumeric characters.) as the networkname.4. Enter the network key on the screen displayed, then click Connect.As a default, the serial number of the machine is used as a network key. Confirm the serialnumber on the rear of the machine.795Downloaded from ManualsPrinter.com Manuals
