The Océ Delivery Tray (optional)Correct use of the Océ Delivery TrayIntroductionTo avoid output problems, attach the Océ Delivery Tray correctly to the printer and adjust theheight according to your printing preferences. For best use, follow the guidelines in the OcéDelivery Tray guide available on"http://downloads.oce.com".When you encounter output problems, use the overview below for help.NOTE• The Océ Delivery Tray is not supported in combination with any of the other finishing devices.• When using the Océ Delivery Tray make sure the [Print delivery] setting in the [Preferences] -[Print job defaults] tab is set to [Back output] and the [Finisher type] setting in the[Configuration] - [Printer setup] tab is set to [Océ Delivery Tray].Problem ActionYour copies are not neatlystackedIt is essential to correctly attach the Océ Delivery Tray to your OcéColorWave 500 in order to get neatly stacked output.Move the Océ Delivery Tray towards the back of the printer, andmake sure you align parallel. Attach the Océ Delivery Tray to theprinter and make sure it is well connected. Following this proce-dure ensures an optimal positioning of the device and minimizesthe chances of damaging your Océ Delivery Tray and the Océ Col-orWave 500.Your copies show dog ears Adjust the position of the left and right output guide flaps to suitthe width of the media you print on. When an output guide flap ispositioned exactly on the edge of your print output, this may re-sult in dog ears.It is advised to leave the middle output guide flap in the exact mid-dle of the Océ Delivery Tray.Your pile of stacked copiesis not flat, resulting incurved copiesAdjust the length of the delivery tray to your print job. Make surethe length is not shorter than the longest print length within yourprint job. If the delivery surface is too small for the copies, thismay result in curves or small creases in your print output.The Océ Delivery Tray (optional)Chapter 2 - Get to Know the Printing System 41
