Canon Optura Instruction Manual

Also see for Optura: Instruction manual

Contents

Canon Optura Instruction Manual Manual pdf 58 page image

MIX SELECT••VARIABLEWhen you play back a tape that was recorded in 12 bit mode, you can set theaudio output to play stereo 1 (the original sound), stereo 2 (any new sound,dubbed to the tape after recording), or mix the balance between the two.To simply choose stereo1 or stereo2, you do not need to release the fixed level(skip step number 2 below).1. Set the camera to VCR mode.2. Release the fixed level (for audio mixing only).Setting the Audio OutputAdditionalInformation58E MENUAUDIOMONITOR(see p. 25)a) Open the VCR menu and point the arrow at MIX SELECT.b) Select the VARIABLE setting and close the menu.3. Choose the output.You can only choose the output using the wireless controller.a) Press the wireless controller’s AUDIOMONITOR button to display “STEREO1”,“STEREO2”, and “MIX”, each in turn.• Your choice is selected approximately 4seconds after you last pressed the button.If you choose “MIX” you can go on to mix thebalance.• Use the cursor keys to choose the mixbalance.Notes:• When you have chosen the output, “STEREO1”, “STEREO2”, or “MIX” isshown in the top left of the display. If you turn the power off the output (anddisplay) is set to “STEREO1”• You cannot mix the balance without first releasing the fixed level: the camerawill show “FIXED” in the display.S TER EO 1 M I XS TER EO 2S T – 1 S T – 2