Canon PIXMA MX340 Network Setup Manual

Also see for PIXMA MX340 Series: Brochure User manual Manual Manual Manual

Contents

ENGLISHACheckConnection ChecklistBefore connecting the machine, are the computer and network device (router, access point, etc.) configured and can the computer connect to the network?Configure the computer and network device.Are the machine and network device (router, access point, etc.) turned on?Is the firewall function of your security software active?A message may appear on the computer monitor warning that Canon software is attempting to access the network.If the warning message appears, set the security software to always allow access.Is the Wi-Fi lamp (A) lit blue?After enabling wireless LAN, perform setup again by following the procedures in "10 Set Up a Wireless Connection" on page 34 and onward in the printedmanual: Getting Started.•Turn on each device.If the machine is already turned on, turn it off, then turn it back on.Check 5Check 4Check 2Check 1For the procedures, refer to the manuals supplied with the computer and network device, or contact their manufacturers.•Select Device settings using the Menu button, then using the [, ] and OK buttons, select LAN settings > WLAN active/inactive >Wireless LAN active to enable wireless LAN.Is the Wireless LAN setup cable connected properly?Connect the Wireless LAN setup cable properly.Check 3For the connection procedure, refer to "Install the Software (2)" on page 36 in the printed manual: Getting Started.•The Wireless LAN setup cable is required for network settings when configuring wireless settings without using the WPS or WCN function.•