Canon PIXMA MX340 Network Setup Manual

Also see for PIXMA MX340 Series: Brochure User manual Manual Manual Manual

Contents

ENGLISH123AACBDSSID•An identifier to identify the specific access point.An access point's periodic transmission of a signal revealing its SSID.Stealth mode•A function to prevent the SSID of the access point from appearing on other wireless devices.SSID broadcast•A function to block access from unauthorized wireless devices by saving the MAC addresses of specificwireless devices (computers, printers, etc.) to the access point beforehand.MAC address filtering•A unique number assigned to each network device.MAC address•Network Key•A password required to set to prevent unauthorized access to communication.GlossaryActionCheck Access Point to Be Used Screen is DisplayedThe message appears when multiple access points withthe same name are found.To use roaming, select Use multiple access points (D), then click OK or Continue(C).When you have only one access pointThe access point selected on the Detected AccessPoints List screen will be used. Make sure that thetarget access point is selected correctly by followingthe procedure below, then proceed with the setup.When using multiple access points (roaming)A unique number assigned to each network device.MAC address•Detected Access Points List screen returns.•For details on how to check the MAC address of the access point, refer to the manualsupplied with the access point or contact its manufacturer.•A function to provide seamless communication when multiple access points with the same SSID are inuse by automatically connecting to another nearby access point upon interruption of signals from thecurrent one.Roaming•CheckAn access point could not be detected. is DisplayedThe message appears when no access point can be detected.Click OK (A) to display the Detected Access Points Listscreen, then try to detect the access point again by referring to"The Target Access Point is Not Displayed (Detected) on theDetected Access Points List Screen" on page 2.GlossaryClick Cancel or Back (A).Select the access point name/network name (SSID) that matches the MACaddress of the target access point, then click Connect.Select Use one access point (B), then click OK or Continue (C).The Check Access Point to Be Used screen is displayed.•