Canon PIXMA MX340 Network Setup Manual

Also see for PIXMA MX340 Series: Brochure User manual Manual Manual Manual

Contents

ACheckProblems during Software InstallationThe Target Access Point is Not Displayed (Detected) on the DetectedAccess Points List ScreenMake sure that you follow Check 1, 2, 3, 4, 6 and7 of "Connection Checklist" on page 11, then clickRefresh (A) to search for the access point again.Check 1Turn off the access point, turn it back on, then click Refresh (A) to search for theaccess point again.Check 2Is SSID broadcast (connection via "ANY" SSID, etc.) disabled or is the stealth modeenabled on the access point?For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•Enable SSID broadcast (connection via "ANY" SSID, etc.) or disable the stealth mode,then click Refresh (A) to search for the access point again.For details on how to change the settings of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•To establish a connection without changing the access point settings, refer to andonward in "Configuring the Access Point's Wireless LAN Settings Manually" on page 9.Check 3If the target access point is not displayed on theDetected Access Points List screen, check thefollowing points.Is "WPA/WPA2 Enterprise" set as a security protocol (encryption standard) on theaccess point?Check 5"WPA/WPA2 Enterprise" is not supported on the machine.Change the security protocol (encryption standard) for the access point, then configuresettings again.For details on how to change the security protocol (encryption standard) for the access point,refer to the manual supplied with the access point or contact its manufacturer.•For the procedure to configure settings of the machine, refer to "10 Set Up a WirelessConnection" on page 34 in the printed manual: Getting Started.•Is the MAC address filtering enabled on the access point?Set the access point to accept the MAC address of the machine.Check 4For details on how to change the settings of the access point, refer to the manual supplied withthe access point or contact its manufacturer.•To check the MAC address of the machine, select Device settings using the Menu button, thenselect LAN settings > Print LAN details using the [, ] and OK buttons, then on the printedLAN setting information, check MAC Address.•For details on how to check the settings of the access point, refer to the manual supplied with theaccess point or contact its manufacturer.•