116Setting an IP AddressIt is possible to send an error notification e-mail (P119) from the projector to the computerwhen you connect the projector to the network.To connect via the network, an IP address must be assigned to the projector. Set an IP addressby following the steps below. (The examples shown are Windows XP screenshot images.)■Setting IP Address1 Connect the projector and a computer directly via a cross type LAN cable.2 Turn on the power of the projector and computer.3 Open [Control Panel] from the [Start] menu, then select [Network and Internet Con-nections] - [Network Connections].4 Right-click [Local Area Connection], and open [Properties].5 Select [Internet Protocol (TCP/IP)] and click the [Properties] button. Take notes of theoriginal network settings (IP address, subnet mask, DHCP settings, etc).6 Select [Use the following IP address] and set as follows:[IP address]: 192.168.254.1[Subnet mask]: 255.255.255.07 When you have specified the settings, click the [OK] button and then click the [OK] but-ton on the [Local Area Connection Properties] window to close it.Commercial cross type LAN cable
