75Setting Display StatusSetting Up Functions from MenusSelecting an Input Signal Type (COMPO-NENT)[Input signal select]You can select a proper component signaltype, if a video image from AV equipmentis not projected correctly.Press the OK button to accept your settingand then press the MENU button.• [Auto] is the factory default.• Refer to the User's Manual of your AVequipment connected to the projector toconfirm the component signal type.Adjusting Input Signal (ANALOG PC) –Total Dots[Input signal settings] - [Total dots]You can adjust the total number of dots inthe horizontal direction. Adjust the numberof dots when noise is displayed on thescreen at both sides.Use [<] / [>] to select a value.When you have completed the adjust-ment, press the MENU button.• Perform this adjustment if the [AUTOPC] function (P50) cannot adjust theproject image correctly.• You can make adjustment either for[ANALOG PC-1] or [ANALOG PC-2].HDMI COMPONENTDIGITAL PC VIDEO/S-VIDEOANALOG PC USBInput signal selectDisplay settingsHDMI COMPONENTDIGITAL PC VIDEO/S-VIDEOANALOG PC USBInput signal settingsDisplay settingsTotal dots
