ID Mode30Selecting the Camera to be Controlled As shown in the figure below, of 4 cameras (ID1 to ID3) only the cameras with IDnumber 2 (2 cameras) are selected for ID mode operation. In normal operation,the camera LEDs turn green.ID1GreenID2GreenID3GreenID2GreenNOTEl Check the LEDs on all the adjacent connected cameras to ensure that all thecameras are receiving the signals from the wireless controller.l Even if the cameras are switched off, when you press the i button the LEDson all the cameras blink orange and you can begin ID mode operation. However,when a number button was pressed in step 2, the LEDs on cameras with IDnumbers that do not match or that have not been assigned an ID number turnred and those cameras are switched off.1. Press the i button.The LEDs on all the connected cameras blink orange (at 0.5-secondintervals).ID1Blinking orangeID2Blinking orangeID2Blinking orangeID3Blinking orangeTo cancel ID mode operation, press the c or i button. TheLEDs on all the cameras then turn green.2. Press a number button (in this case 2).The cameras with ID2 are selected and the LEDs on only thosecameras turn green. The LEDs on the other cameras turn orange(not blinking).ID1OrangeID2GreenID3OrangeID2GreenThis completes the selection procedure. When you use the wirelesscontroller, only the selected cameras will respond. When you press abutton on the wireless controller, the LEDs on the selected camerasblink green (at 0.1-second intervals) and the LEDs on the othercameras blink orange (at 0.1-second intervals).321AF654MF9870 MENUIDHOMEFnBRIGHTON SCREEN∞SET/OK CANCELZOOMTW
