Chapter 77-17.1 Service Mode7.1.1 Service Mode Operation0008-6573a) How to enter Service modeFollow the procedure below to enter Service mode.1) Turn off the printer.2) Turn on the printer while holding down the [Paper Source] button and [Information] button.3) Check that "Initializing" is shown on the display, and then release the buttons.4) When paper has been loaded, pressing the [Online] button twice shows "SERVICE MODE" on the display. When no paper has been loaded, pressingthe he [Online] button once shows "SERVICE MODE" on the display.5) Use the button to make a selection.Service mode is added to the options in the Main menu.Service mode can be entered even during error status (when Exxxx and Wxxxx are shown on the display) by turning the power off and then using the abovekey operation.b) How to exit Service modeTo exit Service mode, turn off the printer.c) Buttons used in Service mode- Selecting menus and parameters: button or button- Entering a lower-level menu: button- Entering a higher-level menu: button- Setting menus and parameters: [OK] button7.1.2 Map of the Service Mode0008-6574The hierarchy of menus and parameters in the Service mode is as shown below.F-7-1ADJUST PRINT PATTERNLF(FUNCTION)DISPLAY PRINT INFSYSTEMYESNOTYPETMP BKTMP CTMP MTMP YTMP PCTMP PMSIZE LFSIZE CRS1L1BKCMYPCPMHEADERRORWARNINGINKSERVICE MODEHEADOPTICAL AXISINK CHECKNOZZLE CHE POS.01~2001~20ADJ. SETTINGRESET SETTINGA1 -127 127(A3, A4 to A6, B1 toB6, C1...)E6 -127 127A2 -127 127YESNOYESNO(I/O DISPLAY) *To be supported by next versionNOZZLESystem SetupTest Print
