Cause Corrective ActionDrying documents stacked on eachother may cause uneven colors.To avoid uneven colors, we recommend drying each sheet separately.Color density may be uneven if youuse Glossy Paper, art paper, orCoated Paper.In Advanced Settings of the printer driver, choose Highest or High in PrintQuality.The type of paper specified in theprinter driver does not match thetype loaded in the printer.Load paper of the same type as you have specified in the printer driver.(See "Loading Rolls in the Printer.") →P.584(See "Loading Sheets in the Printer.") →P.607Make sure the same type of paper is specified in the printer driver as youhave loaded in the printer.1. Hold down the Stop button for a second or more to cancel printing.2. Change the type of paper in the printer driver and try printing again.Scan Wait Time > Area in theControl Panel menu is set to Lead-ing edge.When Scan Wait Time > Area is set to Leading edge, colors may be un-even 110–160 mm from the leading edge. (The position varies depending onthe Print Quality setting.)In this case, select Scan Wait Time > Area > Entire area.However, note that printing will now take longer.(See "Main Menu Settings.") →P.675Image Edges are Blurred or White Banding OccursCause Corrective ActionThe Platen suction is too strong. Set VacuumStrngth to Weakest.(See "Adjusting the Vacuum Strength (VacuumStrngth).") →P.638Close the blue Switch on the platen so that it matches the paper size.(See "Setting the Blue Switch on the Platen.") →P.813The Printhead is set too high. Lower the Printhead.(See "Troubleshooting Paper Abrasion and Blurry Images (HeadHeight).") →P.629The type of paper specified in theprinter driver does not match thetype loaded in the printer.Load paper of the same type as you have specified in the printer driver.(See "Loading Rolls in the Printer.") →P.584(See "Loading Sheets in the Printer.") →P.607Make sure the same type of paper is specified in the printer driver as you haveloaded in the printer.1. Hold down the Stop button for a second or more to cancel printing.2. Change the type of paper in the printer driver and try printing again.Setting the Blue Switch on the PlatenIf printed documents exhibit the following symptoms, adjust the setting of the blue Switch on the Platen.• Image edges are blurred• Image edges are affected by white bandingImportant• Always set the blue Switch on the Platen to the ● side for borderless printing. Printing quality may beaffected if the Switch is incorrectly set.1. Remove any loaded paper that will not be used.• Rolls (See "Removing the Roll from the Printer.") →P.591Troubleshooting > Problems with the printing quality >iPF815 Image Edges are Blurred or White Banding Occurs12813
