Canon iPF9000 series Service Manual

Contents

Chapter 11-47[Adjust Printer][Interface Setup][Maintenance]Setting Item Description, Instructions[Auto Head Adj.] [Standard Adj.] Choose Yes to have the printer print and read a test pattern for the automaticadjustment of Printhead alignment relative to the printing direction.[Advanced Adj.] Choose Yes to have the printer print and read a test pattern for the automaticadjustment of Printhead alignment relative to the nozzle and printing direction.[Auto Print] Choose On to have the printer automatically execute the Advanced Adj. operationsafter you replace the Printhead.[Manual Head Adj] Choose Yes to print a test pattern for adjustment of Printhead alignment relative tothe printing direction. Enter the adjustment value manually based on the resultingpattern.[Auto Band Adj.] [Standard Adj.] Choose Yes to have the printer print and read a band adjustment test pattern forautomatic adjustment of the feed amount.[Advanced Adj.] Choose this option when using paper other than genuine Canon paper, or paper forpurposes other than checking output.Choose Yes to have the printer print and read a band adjustment test pattern forautomatic adjustment of the feed amount. Note that this function takes more timeand requires more ink than Standard Adj.[Manual Band Adj] Choose Yes to print a test pattern for adjusting the feed amount based on the papertype.[Adjust Length] Choose Yes to print a test pattern for adjustment relative to paper stretching orshrinkage, after which you can enter the amount of adjustment.Setting Item Description, Instructions[EOP Timer] Specify the timeout period before cancellation of print jobs that cannot bereceived by the printer.[TCP/IP] [TCP/IP] Specify the TCP/IP protocol settings. To apply your changes, choose RegisterSetting.[IP Mode] Choose whether the printer IP address is configured automatically or a static IPaddress is entered manually.[Protocol] [DHCP] Specify the protocol used to configure the IP address automatically.[BOOTP][RARP][IP Setting] [IP Address] Specify the printer network information when using a static IP address.Enter the IP address assigned to the printer, as well as the network subnet maskand default gateway.[Subnet Mask][Default G/W][NetWare] [NetWare] Specify the NetWare protocol. To apply your changes, choose Register Setting.[Frame Type] Specify the frame type to use.[Print Service] Choose the print service.[AppleTalk] Specify whether to use the AppleTalk protocol. To apply your changes, chooseRegister Setting.[Ethernet Driver] [Auto Detect] Specify the communication method. To apply your changes, choose RegisterSetting.Choose On for automatic configuration of the LAN communication protocol.Choose Off to use settings values of Comm.Mode and Ethernet Type.[Comm.Mode] Choose the LAN communication method.[Ethernet Type] Choose the LAN transfer rate.[Spanning Tree] Choose whether spanning-tree packets are supported over the LAN.[MAC Address] Displays the MAC address.[Init. Settings] Execute? is displayed if you press the button. Choose OK to restore thenetwork settings to the default values.Setting Item Description, Instructions[Maint. cart.] When replacing the Maintenance Cartridge, choose Yes and follow the instructions on the screen.[Replace P.head] Not displayed during a warning message that the remaining Maintenance Cartridge capacity is low.When replacing the Printhead, choose Yes and follow the instructions on the screen.[Repl. S. Cleaner] When replacing the Shaft Cleaner, choose Yes and follow the instructions on the screen.[Change Cutter] When replacing the Cutter Unit, choose Yes and follow the instructions on the screen.You can also reset the cut counter after the Cutter Unit is replaced.[Move Printer] When transferring the printer to another location, choose the level of transfer and follow the instructions onthe screen.