Chapter 1616-33FTPTXPN Specifying the send destination port (FTP) number10 to 65535 (Default: 21)DFDST-L1 Adjusting the dust detection level when DF is used (Inter-paper correction)Setting a greater value makes it easy to detect even small particles.10 to 255(0 to set this mode OFF) (Default: 242)DFDST-L2 Adjusting the dust detection level when DF is used (Post-job detection)Setting a greater value makes it easy to detect even small particles.10 to 255(0 to set this mode OFF) (Default: 242)CCD-LUT Setting whether or not to use LUT for gain correction10: Do not use (Default)1: Use (One-point correction)2: Do not use (Three-point correction)ENVP-INT Setting the in-machine temperature & humidity and fixing temperature logacquisition cycleSelect COPIER>FUNCTION>MISC-P>ENV-PRT andCOPIER>DISPLAY>ENVRNT to set the log acquisition cycles. 10 to 480 (0 for no log acquisition)Default: 60BASE-SW Switching from the MEAP-Full mode to the Base model10: OFF (Base model), 1: ON (Full model)FIX-LOW Improving fixing at low temperatureNote: Valid for iR3570/3570F/4570/4570F only 10: OFF [Default], 1: Low-temperature fixing improvement mode ONSC-L-CNT Switching the threshold value of the paper size (Large/Small) of the scan counter10: Count B4 as the small size [Default]1: Count B4 as the large sizeFIX-CLN Setting the timing at which the fixing pressure roller is cleaned20: No cleaning(Default), 1: Once every 500 sheets at 225deg C regulatedtemperature and 60-second idling, 2: Once every 200 sheets at 225deg C regulatedtemperature and 60-second idling, 3: Once every 100 sheets at 225deg C regulatedtemperature and 60-second idlingCPMKP-SWTurning ON and OFF the sequence of reducing the copy speed to maintain the fixingperformance for copy images 20: OFF, 1: ONHUM-SW switches over charging output settings based on humidity sensor readings2range of settings: between 0 and 5Using the Mode ItemSelect a setting between 1 and 5 to suit the site environment so that the transfercurrent output will be controlled accordingly.low-humidity environment: increases the transfer current outputhigh-humidity environment: decreases the transfer current output1: low humidity2: relatively low humidity3: normal humidity4: relatively high humidity5: high humidity0: automatic control based on humidity sensor reading (default)SCANSLCT Turning ON or OFF the function of calculating a scan area from the selected papersize20: OFF (Determining the scan area by document detection)1: ON (Determining the scan area by paper size)SENS-CNF Setting the arrangement of document detection sensors20: AB type [Default]1: Inch type2: A typeRAW-DATASetting whether or not to print out received data with no changeIf a received image has a problem, the problem is used to isolate the data contentsand image processing. 20: Usual operation [Default]1: Print out with no changeCOPIER > OPTION > BODYSub-item Description Level
