7Saddle Finisher-G1/Puncher Unit-K17-48Handling OptionsFinishing FunctionsThe Saddle Finisher-G1 and Puncher Unit-K1 are equipped with the following functions:■ Collate ModeThis function automatically collates print sets into page order before they are delivered.■ Group ModeThis function outputs all prints of the same page in one set and slightly shifts the outputposition of print sets to make them easier to handle.NOTE• When the Collate or Group mode is set, the tray moves down when each set of paper is delivered.When the delivered paper reaches the stacking limit of the tray, the paper is automatically deliveredto another acceptable tray. When the paper reaches the stacking limit of all the acceptable trays,printing stops temporarily. After you remove the delivered paper from the tray, the tray moves up thecorresponding distance and printing of the remaining sets restarts.■ Offset ModeThis function outputs papers shifted to the front.NOTE• These functions shift each set of output paper about 3/4" (20mm) before delivery, when theCollate function or Group function has been set with “Shift” being pressed, and copies are madeor prints output from a computer.■ Staple ModeThis function automatically collates print sets into page order, staples the sets, andoutputs them.CAUTION• Do not put your hand in the tray’s stapling area when the machine is equipped with theFinisher. Doing so may result in injury.IMPORTANT• Heavyweight paper, envelopes, transparencies, labels, and tracing paper are output to Tray B. (Youcannot staple them.)• You cannot corner-staple or double-staple STMT or STMTR-size paper.• The output tray moves down when each set of paper is delivered. When the delivered paper reachesthe stacking limit of the output tray, printing stops temporarily. Remove all the paper from the tray,and the remaining printing and stapling will restart.• Do not pull copies out of the output area while they are being stapled. Remove the copies after theyare output into the output tray.
