6-24Using the Fax Functions5Press [] or [] to select , andthen press [OK].Fax SettingsTX Start SpeedRX Start Speed6Press [] or [] to select the send start speed,and then press [OK].TX Start Speed33600 bps14400 bps9600 bps7200 bps* When appears in the screen, you must select and press [OK] after specifying the setting.7Press [] (Menu) to close the menuscreen.The setting is complete.Setting ItemsThe following system management settings are available.System SettingsCommunicationsSettingsFax Settings“TX Start Speed” (P.6-24)“RX Start Speed” (P.6-24)“Memory Lock Settings” (P. 6-24)“Select Country/Region” (P.6-24)Restrict Sending“Address Book PIN” (P.6-25)“Restrict New Destinations” (P.6-25)“Allow Driver Faxing” (P.6-25)“Restrict Sending From History” (P.6-25)“Fax No. Confirmation Re-Entry” (P.6-25)“Restrict Sequential Broadcast” (P.6-25)TX Start SpeedChange the transmission start speed if you have difficultystarting a fax transmission.How to display the settings[] (Menu)Settings>Settings(Bold: Default settings)33600 bps, 14400 bps, 9600 bps, 7200 bps, 4800 bps, 2400 bpsRX Start SpeedSpecify the receive start speed if you have difficultyreceiving faxes.How to display the settings[] (Menu)Settings>Settings(Bold: Default settings)33600 bps, 14400 bps, 9600 bps, 7200 bps, 4800 bps, 2400 bpsMemory Lock SettingsNormally, received documents are immediately printed.However, you can specify whether or not to store receivedfaxes in memory before printing. You can then print thestored faxes at any time or delete them without printing tosave paper.How to display the settings[] (Menu)Lock Settings>Settings(Bold: Default settings)OffDoes not use the Memory Lock mode.OnMemoryLock PIN:Seven-digitnumberIf you set a PIN, it will be necessary toenter the PIN whenever you want tochange the Memory Lock mode settings,or cancel the Memory Lock mode.Print Report:Off,OnYou can specify whether or not to printthe receive results when receiving a fax.To use this feature, you must alsoactivate the “Receive Results” feature.MemoryLock Time:Off, OnIf you specify , documents arereceived in the memory only within aspecified time.Enter and respectively.NOTEMemory Lock PIN•If you do not want to set the PIN, press [OK] without enteringany numbers.•You cannot register consecutive digits that consist of only “0” as aPIN, such as <0000000>.•If you register a number that starts from <0>, the PIN changesas follows.Example: When you enter <02> or <002>, the PIN is specified as<0000002>.Select Country/RegionSpecify the country or region where the machine is to beused.IMPORTANTAfter configurationRestart the machine to activate the settings.How to display the settings[] (Menu)Settings(Bold: Default settings)UnitedStates (US), Canada (CA),Brazil (BR), Mexico (MX), Other
