Problems with the printing qualityBanding in different colors occursCause Corrective ActionThe paper feed amount is out of adjustment. Adjust the feed amount.(→P.552)Printing does not proceed smoothly because printjobs are interrupted during transmission.Exit other applications and cancel other print jobs.In the printer menu, Print Length is specied inFeed Priority.Selecting Band Joint may improve printing results.Adjust the feed amount in the printer menu byspecifying Band Joint in Feed Priority and tryprinting again.(→P.552)The Printhead is out of alignment. Adjust the Printhead alignment.(→P.544)The Printhead nozzles are clogged. Print a test pattern to check the nozzles and see ifthey are clogged.(→P.577)Streaks may occur if you set the Print Quality toolow.Choose a higher level of Print Quality in theAdvanced Settings of the printer driver and tryprinting again.Printing in Draft or Standard mode is faster andconsumes less ink than in Highest or High modes,but the printing quality is lower.(→P.211)Load paper of the same type as you have speciedin the printer driver.(→P.118)(→P.150)The type of paper specied in the printer driver doesnot match the type loaded in the printer.Make sure the same type of paper is specied in theprinter driver as you have loaded in the printer.1.Hold down the Stop button for a second or moreto cancel printing.2.Change the type of paper in the printer driver andtry printing again.626 Troubleshooting
