Making Prints Using the Stack Bypass 1-47Before You Start Using This Machine1Making Prints Using the Stack BypassWhen making prints on transparencies, or non-standard size paper stock, load the paperstock in the stack bypass.IMPORTANT• Note the following points when using the stack bypass:- Copy quantity: 1 to about 50 sheets (stack about 1/4" (5mm) high)- Paper size: 4" x 5-1/2" to 11-3/4" x 17" (100mm x 139mm to 297mm x 432mm)- Paper weight: 17-lb bond to 32-lb (64g/m 2 to 128g/m 2 )- Curl down paper before use. (Curl amount: less than 3/8" (10mm) for normal paper; less than1/4" (5 mm) for heavy paper.) There are some types of paper stock which may meet the abovespecifications but cannot be fed in the stack bypass.• Do not load different size/type paper at the same time.• LTR-size tracing paper must be placed vertically in the stack bypass. Placing this paper horizontallymay cause creases on the print, depending on the moisture absorption condition of the paper.• LTR-size transparencies must be placed vertically in the stack bypass. Placing this paperhorizontally may cause blurred images.• When making two-sided prints, select the Two-sided mode. Not selecting the correct mode may,cause creases on the print, depending on the moisture absorption condition of the paper.• To print on the rear side of printed paper, it is recommended you load the paper in one of the paperdrawers.• When printing on envelopes, empty the output tray when at most 10 printed envelopes accumulate inthe tray.• When you select “Free Size” for copying, you cannot use the Auto Zoom, Entire Image, Finisher,Hole Punch, 1 2-Sided, 2 2-Sided, Book 2-Sided, Two-page Separation, Cover/SheetInsertion, Shift (Center/Corner), Booklet, Transparency Interleaving, Image Combination, ImageSeparation, or Image Repeat modes.• When you select “Free Size” for printing documents stored in the mail box, you cannot use theFinisher, 2-Sided, Document Contiguous/Separate Duplex Printing, Cover/Sheet Insertion, orBooklet modes.NOTE• When scanning the following originals, you cannot use Automatic Paper Selection. Use ManualPaper Selection with these types.- Highly transparent originals such as transparencies- Originals with an extremely dark background Standard SizeYou can select standard inch paper, or A or B series paper.
