CarNetix CNX-P1290 V1.0 Installation ManualFigure 13 Removing the existing C134 Power ConnectorNow, insert the CNX-P1290 C134 power cable into the 2-pin Morex PSU power connector (Figure14) and feed the two wires through the hole where the original C134 rear-panel power plug wasinstalled. Connect these two wires to the RED (+12V) and BLACK (GND) wires on J2 of the CNX-P1290.Figure 14 Attaching Morex PSU Power CableMake sure you have connected the correct polarity or you may damage your CarPC system (+ toRED, - to BLACK)! Also, make sure to insulate these connections with electrical tape to preventshort circuiting the outputs.Once you have made this connection, and installed the ACPI cable as described in Case 2, you canreplace the outer shell of the chassis and re-insert the thumbscrews.Steps 5 & 6 are identical to Option 2 above.- 32 -
