Carmanah 502 Owner's Manual

Contents

Carmanah 502 Owner's Manual Manual pdf 13 page image

Owner’s Manual | Model 50213© 2008 Carmanah Technologies CorporationRevised: August 20087.0 AppendicesAppendix A: Original Infrared ProgrammerAll functions of the Model 502 light are controlled by an infrared programmer. Carmanah currentlysupports both the original and the updated infrared programmers. The only differences between the twoprogrammers are the faceplate and setting up the programmers; all other functionality remains the same.Table 7-1: Programmer Buttons describes the buttons for the original Carmanah programmer.See section 3.0 Programming a Light for the light programming procedures.Table 7-1: Programmer ButtonsButton or Symbol Description| Use the OFF-ON button to initiate a programming sequence.S Use the Channel Up button to end a programming sequence.This symbol indicates that a numerical entry is required.A-1: Setting up the ProgrammerThe light is not required to be present when setting up the programmer. Perform the following steps tosetup the infrared programmer:1. Install two AAA batteries.2. Press and hold the Code Search button until the red indicator light lights up, then release the CodeSearch button.3. Press and release the TV button. The indicator light will blink and then remain lighted.4. Enter code 0 0 6 using the number buttons. The indicator light will turn off.The remote is now ready to use for programming the light.Whenever batteries are replaced in the programmer, you need to set-up theprogrammer again using steps 2 to 4 above.If the light does not respond to the programmer, remove and re-install the batteries and set-up theprogrammer again.

/ 16

Related manuals for Carmanah 502