Carmanah 502 Owner's Manual

Contents

Carmanah 502 Owner's Manual Manual pdf 6 page image

Owner’s Manual | Model 5026© 2008 Carmanah Technologies CorporationRevised: August 20083.0 Programming a LightYou can customize the light settings using the programmer. Before programming the settings you musttransition the light and enter the security code. You can then program the settings listed in Table 3-1:Programmable Settings.Table 3-1: Programmable SettingsSetting SectionChange the flash pattern 3.4Set automatic light control 3.5Turn the light off:Storage mode 4.1Sleep mode 4.2Turn the light on 4.33.1 Transitioning the LightTo make any change to the settings of the light, you must transition the light from night to day mode. Thelight only accepts programming commands while it is exposed to light. The light cannot be programmed indarkness. After transitioning the light you must enter the security code in order to proceed with theprogramming; see section 3.3 Entering the Security Code.If, after transition, the light does not respond to the programmer, remove and re-install the programmerbatteries and repeat the programming instructions for the required function.Transition a new light:1. Remove the light from the shipping box and place it in full sunlight or under an incandescent light forat least 3 seconds.2. Move the light into darkness and wait 3 seconds.3. Move the light back into the light.4. While the light is exposed to the light, point the programmer at the light and press the Start button;when the light responds with a flash, it is ready for programming.Transition an installed light:During the day:1. Cover the light with an opaque material for at least 3 seconds.2. Uncover the light.3. While the light is exposed to the light, point the programmer at the light and press the Start button;when the light responds with a flash, it is ready for programming.At night:1. Force a transition to day by placing the light under an incandescent light for at least 3 seconds.2. While the light is exposed to the light, point the programmer at the light and press the Start button;when the light begins to flash, it is ready for programming.3.2 Programming SequenceThe infrared sensor in the light responds to commands from the programmer for 1 minute after transitionof the light. The infrared sensor switches off automatically after 1 minute to conserve power.