Carmanah A704-5 Owner's Manual
                                                   | |
Contents
| 
Owner’s Manual | Model A704-5 Aviation Lighting System24© 2008 Carmanah Technologies CorporationLast revised: April 2008Lights with radios that have needed one or more automatic restarts will identify themselves to the remoteoperator by responding with five flashes:To send the Radio Health Diagnose (Clear) command to the lights: Press FLASH Press ENTERAll lights will flash five times indicating the radio health count has been cleared. A subsequent RadioHealth Diagnose command will not produce a five-flash response until the radio module is restarted.To exit Diagnose Mode on the controller: Press DIAGNOSE (The DIAGNOSE LED starts flashing) Press ENTER (The DIAGNOSE LED turns off)5.7.3 Group ControlUp to eight individual groups of lights can be created, with any number of lights included in each group,and controlled independently. This feature provides added flexibility in controlling a complete airfieldlighting system. The controller sends commands to one or more groups indicated by the LEDs on thecontroller labeled Active Groups. The factory default setting has all lights initially assigned to group one.Each light can be assigned to only one group at a time, but can be easily reassigned to another group asrequired. To select one or more groups of lights to control: Press SELECT GROUP. Press the group number(s) using the buttons 1 through 8. Press ENTER.Commands entered now apply only to the groups indicated by the Active Group LEDs.5.7.4 Configure GroupsTo configure a subset of lights as a group:Enter Configure Mode on the controller: Press CONFIG (The CONFIG LED starts flashing) Press ENTER (The CONFIG LED is on)Then send the Configure Group command to the lights: Choose a number from 1 through 8 for the new group. Press the corresponding number on thekeypad. For each individual light you wish to add to the selected group, press the switch on each light. Thelight is now prepared to receive its group assignment. The light will listen for its group assignment for5 minutes Press ENTER on the controller to assign the groupThe controller will transmit the group assignments and the light will flash to indicateacceptance. Do not use the switch on lights that you do not want in the new groupwhile the group assignment process is underway. They will be added to the group.When you provide group assignments, lights that are already members of that groupwill remain members after the assignment process is complete. This means that youcan add lights to a group as you go, without having to re-assign all lights in the groupAny one light cannot be a member of more than one group. |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine