Casio CASSIOPEA IT-10 SERIES User Manual

Also see for IT-10 Series: Hardware manual

Charging the Battery with the AC AdaptorPull back the rubber cover from the AC adaptor jack and insert thecable. The battery pack takes about two hours (when the Rugged PDAis turned off) to fully charge, and then the left side indicator LED lightsgreen. When the battery pack is fully charged, remove the AC adaptorcable and be sure to replace the rubber cover to its original position.Remove the AC adaptor cable in the following order q w e.If the left side indicator LED goes out during charging, then the internalprotection circuit may have terminated charging. If this happens, re-move the AC adaptor and the battery pack from the Rugged PDA andthen reattach them again and then start charging again. If this hap-pens frequently it may indicate a malfunction, contact your originalretailer or authorized distributor.Note• You can use the Rugged PDA while it is charging. However,the time to charge the Rugged PDA may vary greatly de-pending on the operations (and temperature or other factors).• Charging requires a longer than normal time when doing ini-tial setup immediately after purchase or when charging anewly purchased battery pack for the first time.qewUse the AC adaptor specified by the manufac-ture. Using the AC adaptor that is not specifiedby the manufacturer may cause a fire.