149Manager operationCE-7000/TK-7000/TK-7500/TK-T500//TK-6000/TK-6500 Dealer's ManualManager operationThis section describes modes and operations that are generally used by management only. Besides user programmingprocedure, it also describes how to perform clerk assignments for clerk interrupt function and set stock quantities.Manager control mode (X1 mode)Manager control consists of the six operations listed below. Access to these operations can be restricted by password thatmakes it impossible to perform operations unless the correct password is input.• Drawer assignments for each clerk (when optional multi-drawer system is used)• Stock quantity maintenance• Clerk assignment for clerk interrupt function• Clerk number to clerk number key• Programming for the Euro• Program 1 programming (programming unit prices for department keys, PLUs; programming unit prices, rates, times, datesfor function keys)Entering the manager control modeProcedure6 o 6 : : : : 6 k 6Mode switchX1 MGRPassword (4-digit)1. If the register has no password for the manager mode, you need not to enter it.2. Press the clerk number key if you want the password you input not to appear on the display.3. An error occurs if you try to enter the manager control mode without inputting a password (when one is programmed), or ifthe password you input does not match the one programmed for the register.To avoid repetition, the above operation is abbreviated to the following for all of the other procedure in this section.Assign drawers for each clerkProcedure (by clerk button/key)6 6 : 6 rMGR Drawer assignmentDrawer 1 = 0, 1Drawer 2 = 2Drawer 3 = 3Drawer 4 = 4Sign on by clerk button/key6 : 6 : : : : 6 rMGR Drawer assignmentDrawer 1 = 0, 1Drawer 2 = 2Drawer 3 = 3Drawer 4 = 4Clerk No.Procedure (by clerk code)Note:1. Each clerk can be assigned a drawer when optional multi-drawer system is being used.2. Drawer number 0 ~ 2 (TK-6000/6500, CE-6000/6100, CE-T300), drawer number 0 ~ 4 (TK-7000/7500, CE-7000, TK-T500)3. Input a 4-digit clerk number (0001 ~ 9999) that identifies the clerk you want to assign the drawer to.- Version 1.0.1
