E-12Using Built-in Tones1. Press the cs (FUNCTION) button.The FUNCTION lamp will light and the function screenwill appear on the display.2. Use the do (i) and dn (u) buttons to selectthe Tmpr/Effect screen.3. Press the dp (ENTER) button.This will display a screen for selecting settings in theTmpr/Effect group.4. Use the do (i) or dn (u) button to selectthe brilliance screen shown below.5. Use the ct (w, q) buttons to adjust thebrilliance of the currently selected tone. Youcan adjust brilliance in the range of –3 to 0 to 3.6. Press the cs (FUNCTION) button.This will exit the brilliance screen and cause theFUNCTION lamp to go out.NOTE• See “Other Settings” (page E-43) for details aboutusing the cs (FUNCTION) button.1. While holding down the cs (FUNCTION)button, press the dk (REVERB) button.This will display a reverb type selection screen.2. Use the ct (w, q) buttons to select thereverb type you want.• The following shows the five available reverb typesettings.0: OFF (no reverb)1: Room2: Hall3: Large Hall4: Stadium3. Press the cs (FUNCTION) button.This exits the reverb type selection screen.Adjusting the Brilliance of aTonew : Mellower and softerq : Brighter and harderLitAdding Reverb to the Tone
