E-83Useful featuresAdvanced programmings and registrationsProgramming functions of departments and PLUs individuallyProgramming functions of departments individuallyThis part explains programming methods of each function of departments indi-vidually.Step Operation1 Turn the Mode switch to PGM position and select [SystemSetting] then press F key.>▪▪▪▪▪>F2 Enter 3 and press o key to set the register in theprogramming mode.3o3 Referring the following table, enter two-digit set code youwish to program followed by two 6s. The “66” is the identifi-cation code for individual programming of departments andPLUs. Then press o key.BB66o(set code)4 You can skip this step if you program in departments 01through 30. If you wish to program in departments 31through 60, press DEPTSHIFT/DEPT# key.DEPTSHIFT/DEPT#5 Referring the following table, enter program code and pressthe department key in which you wish to set.123#This example is for linking dept. 03 to itemgroup 123 assuming set code 11 has beenentered in step 3 and DEPTSHIFT/DEPT# key is not pressedin step 4.6 If you wish to set the same function in another department,press the corresponding dept. key.$This example is for setting the same linkinggroup in dept. 04.7 Repeat steps 4 and 5 to set another function in anotherdepartment.8 Press o key to complete the program. o