Casio TE-3000S Dealer's Manual

Also see for TE-3000S - Cash Register: User manual Content navigation Service manual

Contents

246Appendix (Error code)Error code (…continued)Errorcode Message Meaning ActionE051E053E054E055E059E060E061E062E064E066E070E071E073E075E085E099E100E101E103E105E106E110E121E139E140E146E164E165E166E176E200E203E205CHK/TBL No. isoccupiedCHK/TBL No. isnot openedOut of CHK/TBLNo. rangeIn the SEP CHKoperationPress EAT-IN orTAKE-OUT keyPrinter offlinePrinter errorPrinter paperendPrint bufferfullPrint from thebeginning of thetransactionTarget print terminal busy/downTarget terminalprint BF fullYour receipt/order may not be issuedNegative balancecannot befinalizedData exist inconsolidationfileCheck NFP itemsOperate at themaster terminalPLU maintenancefile full. Press<#2> to exitPLU Code is notexist. Input PLUCodePLU file fullItem exists inthe PLU FILEMaster is busy/down. Retry:Remove:Inline startuperrorNegative balanceis not allowedWrong menuArrangement filefullEmployee No. isnot Found in theEmployee FileEmployee No. isnot Clocking-inEmployee No. isOccupiedTime&Attendancefile fullInsert CF cardInsufficientmemoryFile alreadyexist.Attempt to made use to open a new checkusing a number that is already used for an existing check incheck tracking memory.Attempt made to use reopen a new checkusing a number that is not used for an existing check in checktracking memory.Check number range over.Normal registration is prohibited during separate checkoperation.Attempt to finalize a transaction without specifying IN> or .External (local) printer offlineExternal (local) printer went down.External (local) printer paper endExternal (local) printing buffer fullAttempt to print the last separated transaction on slip.The terminal connected with the external (remote) printer isbusy or goes down.The print buffer of the terminal connected with the external(remote) printer becomes full.The terminal connected with the external (remote) printergoes down,Attempt to finalize a transaction when balance is less than orequal to zero.Data exists in the consolidation file.Disable to read/reset or consolidate the not found PLU item.Prohibit master operation.Scanning PLU direct maintenance/batch maintenance filebecomes full.The PLU code you input is not existed in the PLU file.Scanning PLU/not found PLU file fullThe designated item has already existed in the scanning PLUfile.The check tracking master terminal is busy or goes down.Network startup error.Attempt to register <–> or when the balance becomesnegative.This sheet holder is prohibited by PGM.Arrangement file is full.The employee number does not exist in the employee file.The employee number has not been clocked-in yet.The employee number has already been clocked-in.Time and attendance file becomes full.No CF card is set.Insufficient memory in the CF card.Can not write, because designated file has already been in theCF card.Finalize and close the check that is currently under thenumber that you want to use or use a different check number.Use the correct check number (if you want to reopen a checkthat already exists in check tracking memory) or use CHECK> to open a new check.Enter correct number.Terminate separate check operation.Press or .Replace new paper.Print from the beginning of the transactionRegister item(s) until the balance becomes positive amount.Clear the data.Perform it at master terminal.Terminate the maintenance.Input the correct PLU code again.Modify the designated item.Follow the prompt message.Enter proper minus/coupon amount.Set correct sheet holder.Set the arrangement properly.Enter the correct employee number.Enter the correct employee number.Enter the correct employee number,Issue the time and attendance reset report.Set CF card.Use a vacant (formatted) CF card.Check the operation and retry.